Peugeot 308 Key Fob Problems and How to Fix Them

If your peugeot 3008 key programming 308 key fob stopped working after a few days it could be due to a dead battery in the coin or water damage or receiver module issues, or a damaged electronic chip. Luckily these are all easy to fix and you'll be able to get your vehicle back to normal in no time!

Car keys can also fail due to the fact that the blade on the key gets worn. You can easily fix this problem by visiting your local Car Key Man Auto Locksmith to get a new blade installed.

Battery

The battery that powers the key fob on your peugeot spare key 308 can sometimes die or become insufficient to send an energizing signal to the car. This could cause the key fob to stop functioning and prevent you from locking or opening the doors or starting your engine. You'll require a new battery for your key fob to fix this.

You'll need to purchase the replacement key for peugeot 207 battery from an auto parts store or your local hardware store. Make sure the battery is brand new and has not on the counter for too long. A new battery has greater capacity and will transmit a stronger signal your car.

After replacing the battery, try unlocking the doors and locking them using the key fob. If the doors don't unlock the issue is likely to be with the receiver module of your car, which can be reprogrammed by your local Peugeot dealer.

It's also possible that the chip inside your key fob is damaged. This could happen if drop your key fob on the ground or expose it to water. The rubber seals that shield the chip from moisture could wear down over time, especially if your key ring is exposed to water for lengthy durations, like submerging it in the ocean at the beach. To avoid this you should keep your key fob clear of moisture and away from water.

Water Damage

Don't lose hope on your key fob when it gets wet, whether you dropped it into an aquisition or stumbled into a water puddle. The key fob is protected by rubber seals, however, prolonged exposure to water can cause damage to its electronic chip. Because water is an excellent conductor so any water that makes it inside the key fob can result in a series of short circuits that eventually destroy the chip. After removing the batteries, clean the contacts using isopropyl and then dry them completely before putting them back into.

Your Peugeot 308 may not start because of a dead battery. If you have a spare car, jumper cables could be used to get the engine working again. If the battery is the problem and it is not working, it should be replaced.

Another reason could be a bad receiver in the vehicle, which may prevent it from receiving a signal from the key fob. It could be due to a issue with the antenna, or wiring or the key fob could be damaged. If you have a new key fob it could need to be programmed to the vehicle. If you are unable to solve the issue, call a professional technician. A technician who is trained in the field will be able to identify the issue quickly, and fix it immediately.

Radio Interference

Signs like key fobs that are not recognized or having a limited range often mean that there is a problem with the system. This is either radiated or conducted, with the latter resultant from power supply cables or speaker wiring passing too close to electrical components. In general, rerouting cables or moving them away from these components can solve the problem.

It's unlikely that anyone is listening in on the signals from your key fob to steal your car, but it's possible that your signal has been drowned out by radio frequency interference. This is a simple issue to fix.

If you're experiencing a problem with your key fobs that aren't being recognized, try a fresh battery. Also, ensure that the battery is the right type and size. Batteries of the wrong size can cause damage to your device.

Some alarm systems that are sold on the market and radar detectors use the same radio frequency as your key fob and could cause them to interfere with your key signals. Avoid connecting these devices to your key fob.

Pairing Issues

The remote keyless entry system contains an antenna that receives radio frequency signals from the key fob. If this receiver has developed problems, you won't be capable of starting your car even if the key fob is functional and is reprogrammed. This issue can be caused by a variety of ways, such as an inoperative battery on the coin-cell or water damage. The receiver could also be failing because of a software bug or internal damage to the key.

The battery inside your peugeot 306 key replacement 308 keyfob has probably died. The battery can be easily replaced, but you need to be sure it's the right battery for your keyfob. It is best to choose one that is the same size in terms of voltage, size, and specifications as the original.

Your Peugeot 308 keyfob may not function if it was connected to a different vehicle. This could be the case if you have given your key fob to a friend or when the key has been used to unlock and start other vehicles. You can fix this by reprogramming your key fob using an OBDII scanner. This tool will usually ask you to provide certain details about the vehicle, such as the VIN or engine type, so it's essential to enter this correctly.