fiat ducato key fob replacement 500 Replacement Key Fob

If your 500 remote key fob has stopped working, it might be time to replace the battery. If you replace the battery, but it isn't working it could be a problem somewhere else.

At United Locksmith, we specialize in the creation of new keys for classic automobiles. We have all the tools and components needed to perform this service.

Dead Coin Battery

The most frequent reason that your Fiat 500 key fob will not unlock or lock the doors is a dead battery. The key fob is equipped with the battery of a coin-cell that is prone to draining quickly in the event that it is not used often enough. If your remote starts to show signs of loss of range or stopped working or not responding, then the battery could be dead.

The battery inside the key fob is held in place by metal clips that retain it. If the clips aren't tight enough, it could lead to contact issues, which could prevent your remote from receiving power. Using a small flathead screwdriver, pull the retaining clip outwards to remove the current battery, and replace it with a brand new one. Make sure to use a battery with the same voltage, size and specifications as the original.

The key fob can also be damaged or corroded by exposure to water. Even a small bath in soapy water can cause damage to the electronic chip inside. Make sure your key fob is dry.

Water Damage

If your key fob doesn't work properly, it may be caused by water damage. The rubber seals on key fobs keep them from getting damaged by a small splash or drizzle of water. However, it is crucial to keep your keys of your car away from the washing machine, the ocean and the pool.

The key fob is equipped with an electronic chip in it that transmits a signal to your car's immobilizer system. The chip allows the 500 to be locked and started. If it gets wet, however it won't work.

If you want to check whether your key fob functioning You can clean the internal electronics using isopropyl or electronic cleaner. However, it is probably recommended to purchase a replacement from a dealership instead of trying to fix an item that has been submerged by salt water.

While a replacement fob can cost a little money, it's a lot cheaper than having to pay for your fiat scudo key replacement 500 to be towed to the dealership and repaired! You can also do it yourself with the simplest of steps. Make sure you have the correct battery type before you attempt to open your keyfob. There are step-by-step directions for every car keyfob online.

Faulty Chip

The chip located within the key fob communicates with the car's immobiliser unit to make sure the vehicle is only able to start when the correct key is inserted. If the chip is damaged, or corrupted it won't allow your car to start no matter what you do.

A chip that is damaged can happen due to a variety of reasons, but the most common reason is water damage or an unresponsive battery. It is best to delegate the task to a professional locksmith who can replace the chip quickly and at an affordable price.

If your key fob does not work after exposure to clean water from a tap or rain take it off the battery. Clean the electronic component using an old towel. If the key fob still isn't working it's likely to be to be a damaged chip and will require replacement.

A few people will visit their dealer when they require a new fiat replacement key cost fob. However, this can be costly. If you are looking for a low-cost solution to have your fiat replacement car keys key fob fixed Look no further than United Locksmith. We have the tools and experience needed to fix your fiat punto replacement key fob in a professional and timely manner.

Faulty Receiver Module

Fiat key fobs send a signal to the vehicle that will unlock and close doors (and start the car for those with an automatic transmission) up to 50 feet. There are a variety of reasons why a fob could stop working. This includes a dead coin battery damaged by water buttons, worn ones or a problem with the receiver module and signal interference, or an electronic chip malfunctioning.

If the fob is stored in a place that has experienced extreme trauma, like being dropped on hard floor or being washed in a wash machine and it isn't capable of communicating with the car's Body Control Module (BCM). This is because the BCM is a secure system that can only accept a signal from a genuine key, and not from any other.

You will need to replace the fob if this happens. A professional locksmith can handle the entire process of replacing keys including programming a brand new key for your 500. They can even offer a clone fob that works the same as the original (and costs just a fraction of what it would cost).